Flywheel Timing Mark Position In Crankcase Inspection Hole

FRONT PISTON POSITION BEFORE TOP DEAD CENTER ON COMPRESSION STROKE G, GA 9. 32" XL.XLH 11.16" FL, FLH 7.16"

Figure 5F-3. Ignition Timing - Schematic -Manual Advance Circuit Breaker

TIMING REAR CYLINDER. Connect one test lamp wire to circuit breaker black wire (12A, Fig. 5F-2) (rear spark coil terminal) and the other wire to the battery positive terminal. Ground battery negative terminal to engine.

Fully advance circuit breaker.

Turn engine flywheel shaft in direction in which it runs until the mark cm the cam approaches the cam follower fiber cm the rear cylinder breaker points.

Continue rotating engine very carefully in same direction until timing mark for rear cylinder (marked "R" on flywheel). is aligned in inspection hole as shown in Fig. 5F-3.

Crankcase screw(2)

Stem

Gasket

0 0

Post a comment