Headlamp Dimmer And Horn Switch

This type switch has the headlamp dimmer switch and horn button combined in one unit located on the handlebar. High and low beams are operated with flip switch. Button operates horn. See Figure 5C-1B.

1. Steering Damper Adjusting Knob 3. Headlamp Clamp Nut

2. Terminal Plate

1. Steering Damper Adjusting Knob 3. Headlamp Clamp Nut

2. Terminal Plate

1. Door Screw

2. Head Lamp Door

3. Retaining Ring Screws

4. Retaining Ring

5. Cycle Beam Sealed Unit

6. Connector Block

Headlamp

1. Door Screw

2. Head Lamp Door

3. Retaining Ring Screws

4. Retaining Ring

5. Cycle Beam Sealed Unit

6. Connector Block

The headlamp is a sealed-beam type, specially designed and made for Harley-Davidson motorcycles. When replacement is required, use only the prescribed sealed-beam unit. Do not attempt to use an automobile sealed-beam unit because the current requirements for a motorcycle are much less than for an automobile and damage to battery or generator will result. If either filament burns out, or the lens breaks, the entire unit must be replaced. Do not attempt to repair a defective sealed-beam unit because when the seal is broken the reflector tarnishes and poor light and road visibility result.

0 0

Post a comment