Info

Figure following name of part indicates quantity necessary for

Figure following name of part indicates quantity necessary for

38. Brush holder screw nut (2)

39. Brush holder (negative)

40. Terminal screw nut (2)

41. Terminal screw lock washer (2)

42. Terminal screw insulating washer (2)

43. Field coil terminal insulator (2)

44. Field coil terminal

45. Terminal screw (2)

46. Terminal screw bushing (2)

47. Brush holder (positive)

48. Brush holder insulation

52. Air intake shield screw (2)

53. Air intake shield (2)

54. Spacing bushing (2)

55. Generator frame one complete assembly.

In step three, touch one test lead to generator frame, the other to either of two field coil leads, making sure other lead from same coil does not touch generator frame. Repeat process on other coil.

Omit step four.

In place of step five, touch ammeter leads to two field coil leads. Repeat process with opposite coil. Ammeter should read 1 ampere in both cases. No reading indicates an open coil, a higher reading indicates a shorted coil.

In step six, touch one test lead to generator frame, the other to positive (insulated) brush holder.

0 0

Post a comment