Info

Key for Wiring Diagram

12. STOP LAW V SWITCH - Cable "F" red wire from Junction terminal (50); cable "F " black wire from junction terminal (48).

13. RELAY - Cable "B" red wire from »»itch terminal (1) to relay terminal marked ••BAT"; cable "B" black wire from junction terminal (44); cable "B" green »Ire from generator "relay" terminal (23).

14. TAJL AND STOP LAMP - Loom "G" red »Ire from Junction terminal (50); loom "G" green, »ire from junction terminal (47).

17. JUNCTION TERMINAL - (front terminar—left side, in headlamp bracket) - Cable •'C" green »Ire from switch terminal (2), loom "D" red »Ire »ith bUck tracer from handlebar toggle swUch (16).

18. HANDLEBAR TOGGLE SWITCH - Loom "D" black wire with red tracer from headlamp larger terminal sere*», loom "D" red wire "with yellow tracer from headlamp smaller terminal screw; loom "D" red wire with black tracer from Junction terminal (17).

19. HORN SWITCH - Loom "D" black from horn (20).

$. SWITCH TERMINAL - Black wire from junction terminal (6).

6. JUNCTION TERMINAL - Cable "C" black wire from horn (20); black wire from oil signal light (29); black »Ire from generator signal light (28); black wire from switch terminal (5); cable "A" black wire from Junction terminal (48).

7. JUNCTION TERMINAL - Cable "A" yellow wire from terminal (49); green wire from oil signal Ught (29).

8. SPEEDOMETER LIGHT - Green wire from switch terminal (2).

». BATTERY POSITIVE TERMINAL (left side) - Loom •C" red wire from junction terminal (46).

10. BATTERY NEGATIVE TERMINAL (right side) - Black wire from ground terminal on frame.

11. OIL PRESSURE SIGNAL SWITCH - Cable 'T" green < Irom junction terminal (49).

20. HORN - Cable "C" black »ire from Junction loom "D" black wire from horn »witch (19).

21. HEADLAMP • Loom "D" bUck wire with red tracer from handlebar toggle switch (18) to larger terminal screw; loom "D'" red wire with yellow tracer from handlebar toggle switch (18) to smaller terminal screw. NOTE: Headlamp Is shown in upside down position.

22. GENERATOR "SWITCH" TERMINAL - Cable "B" green wire from switch terminal (2).

23. GENERATOR "RELAY" TERMINAL - Cable "8" green wire from relay (IS).

24. IGNITION-LIGHT SWITCH (top view) - Switch positions for off, Ignition only, Ignition and running lights and parking " *' ' " Figure 4. 9»Itch can be locked in off only, using head lock key, a coin, or

28. GENERATOR SIGNAL LIGHT (marked • GEN") - BUck »ire from Junction terminal (6); greer, wire from junction terminal (44).

29. OIL PRESSURE SIGNAL UGHT (marked •OIL") - BUck wire from Junction terminal (6); green wire from junction terminal (7).

30. JUNCTION TERMINAL (front terminal - right side, in head-Ump bracket) - Cable "C" red »ire from switch terminal (1). This is t live terminal and can be used for accessory Umps Independent of ignition-light switch.

25. IGNITION COIL - BUck »ire from Junction terminal (48); bUck wire from circuit breaker (26).

26. IGNITION CIRCUIT BREAKER - BUck wire from coil rear terminal.

36. MUDGUARD LAMP - BUrk wire from junction terminal (51).

44. JUNCTION TERMINAL - Grefi light (28), cable "B" bUck «ire

45. JUNCTION BOX - Located behind ignition coll.

46. JUNCTION TERMINAL (upper left hide terminal in junction bo*) - Cable "A'" fed wire from switch terminal (I); loom "G" red »Ire from battery positive terminal (9).

47. JUNCTION TERMINAL (upper right side terminal Ui junction box) - Cable "A" green wire from switch terminal (4); loom "G" green wire from Ull and slop lamp (U).

48. JUNCTION TERMINAL (center left side terminal In Junction bo*) - Cable "A" bUck »Ire from junction terminal (6); cable "F" bUck wire from stop lamp »witch (12); bUck wire from coil front terminal.

49. JUNCTION TERMINAL (lower right side terminal in Junction ■ box) - Cable "A" yellow wire 17om~Junctlon terminal (7);

cable "F" green wire from oil pressure signal »witch (11).

50. JUNCTION TERMINAL (lower leit side terminal In Junction box) - Loom "G" red wire from tall and stop Ump (14); cable "F" red wire from stop Ump switch (12).

51. JUNCTION TERMINAL (In front mudguard and horn bracket) - Black wire from mudguard Ump (36); cable "C" yellow wire from switch terminal (3).

NOTE: Side Car Tail and Stop Lamps - In sidecar or package trunk service, if the sidecar or package truck Is equipped with a tail and stop Ump, the green wire of the Ump cable Is connected to terminal No. 4? and red wire to terminal No. 50 In the Junction box (45).

Key for Wiring Diagram

A. FOUR wnz CABLE •• Red, Green, Black and Yellow vires from switch and Instrument panel but terminals «1, M, H and »1. Right (ront cable in panel base to terminal box behind ignition coll.

B. THREE WIRE CABLE — Red, Green, and Black wires from switch and Instrument panel base terminals '1, »2 and »44. Left cable In panel base, to generator and cut out relay.

C. FOUR WIRE CABLE -- Red, Green, Yellow and Black wires from switch and instrument panel base terminals »1, »2, 13 and M. Right rear cable in panel base, to terminal plate on fork.

D. HANDLEBAR WIRING (Loose Wires) -- Red wire «Ilk black tracer. Black wire with red tracer and Red wire with yellow tracer, Irom headlamp switch on handlebar to terminal plate terminals M, »21 and »22. Black wire from Born Switch to terminal plate terminal »24,

B. TWO WERE CABLE — Red and Green wires from terminal plate terminals »24 and »25 to horn.

r. THREE WIRE CABLE Black. Green and Re« wires <rom terminal box, terminals »41, M2, MJ to oil pressure switch and stop lamp switch.

1. SWITCH TERMINAL - Red wire through cable A" to terminal (3D; red wire through cable -B" to relay (13); red wire through cable "C" to terminal (I®).

2. SWrTCB TERMINAL - Green wire through cable "C" to terminal (t); freea wire through cable "8" to generator •switch" terminal (32); green wire to speedometer light (I).

5. SWITCH TERMINAL - Black wire to jwction terminal (•).

I. JUNCTION TERMINAL - Black wire through cable "C" to terminal (24); Mack wire to oil pressure signal llgM (2»; Mack wire lo generator light (ZI); black wire to switch terminal (S); black wire through cable "A" to terminal (41).

7. JUNCTION TERMINAL - Yellow wire through cable "A" to terminal (42); green wire to oit signal tight (2»),

«. SPEEDOMETER LIGHT - Green'wire lo switch terminal (I).

9. TERMINAL • Green wire thresh cable C to switch terminal (2); red wire with black trscer throt*h cable "D" to head lamp toggle switch (16).

10. TERMINAL •• Red wire through cable "C" to switch terminal {!). This is a live terminal and can be used lor accessory lamps, etc. independent of ignition-light switch.

11. TERMINAL • Not used with standard wiring.

12. TERMINAL - Not used with standard wiring.

13. CUT OUT RELAY - Red wire from relay terminal marked "BAT" through cable "B" to switch terminal (i); black wtre from Junction terminal (44) through cable "B" to relay ; green wire from generator "relay" terminal (33) through cable "B" to relay.

14. TAIL AND STOP LAMP - Red wire thro^h loom "J" and loom "G" to terminal (43); green wire through loom "J" and loom "C to terminal (40).

15. BATTERY POSmVE TERMINAL - (left side) - Red wire through loom "G" to terminal (3W.

0 0

Post a comment