Info

Shock absorber unit

Figure 2F-18. 1966 and Earlier Rear Shock Absorber - Exploded View

Figure 2F-18A. 1967 & Later Rear Shock Absorber -Exploded View

Cover clamp with screw and nut .

Top cover V,

Mounting stud nut (2) ^ Mounting stud plain washer (2) (1964) ,

Stud rubber bushing (4) Cam support '

Cover Jh«fflL ^ Spring (SLlliR) f| Lower cam c "J

Spring rotating cam (1964) Rotating cam 1965 & later Cam sleeve Seal washer Spacer washer (3 std.) Shock absorber /ifj

Roll pin

1967 AND LATER (Fig. 2F-18A)

Remove top and bottom mounting stud nut (1), upper stud cover (2) if used, and cup washer (3). Slip shock absorber assembly off upper and lower studs. Push rubber bushings (4) from shock absorber mounting eyes. Remove retaining ring (5) from assembly. Place shock absorber in Rear Shock Absorber Tool, Part No. 97010-52A with split key (6) up. Compress absorber spring enough to remove each half of split key (6) from flange on shock eye. Release spring compression and remove absorber assembly from tool. Remaining items can be removed in order shown in Fig. 2F-18A.

0 0

Post a comment