Check At First 1000 Miles

1. Drain oil tank and refill with fresh oil.

2. Replace oil filter.

3. Check level of oil in transmission and add oil if needed. Use same grade of oil used in engine.

4. Service air cleaner.

5. Check adjustment of chains and adjust if necessary.

6. Check lubrication and condition of front chain, and check chaincase vacuum with gage, Part No. 96950-68

7. Check lubrication and condition of rear chain and readjust chain oiler if necessay.

8. Check level of solution in battery, and add distilled water if needed. See that terminals are clean and connections tight.

9. Check circuit breaker point gap and condition and adjust if necessary.

10. Check brake adjustment and hydraulic fluid levels.

11. Check clutch adjustment.

12. Check tire pressure and inspect tread.

13. Check all nuts, bolts and screws, and tighten any found loose to specified torque.

14. Check and tighten spokes.

15. Check carburetor controls and adjustment.

16. Lubricate all controls and fittings.

17. Inspect brake linings and discs.

18. Road test.

Above operations are described fully in section pertaining to particular part of motorcycle. See table of contents for location.

0 0

Post a comment