Check At First 500 Miles

1. Drain oil tank through drain plug, flush with kerosene and refill with fresh oil.

2. Replace oil filter. Clean overhead valve/tappet oil supply screen.

3. Drain transmission through drain plug and refill to level of filler opening with fresh oil. Use same grade oil used in engine.

4. Lubricate all points indicated for 1000 mile attention in the regular service intervals chart.

5. Aim headlight.

6. Inspect and service air cleaner if needed.

7. Check adjustment of chains and readjust if necessary.

8. Check lubrication of rear chain and readjust chain oiler (if provided).

9. Check wheel and brake disc mounting bolts and tighten if needed. These bolts must be tightened to specified torque.

10. Check level of solution in battery and add distilled water if needed. See that terminals are clean and connections tight.

11. Check tightness of all cylinder head bolts and all cylinder base nuts, and tighten where necessary to specified torque.

12. Check brake adjustment, hydraulic fluid level and hydraulic line connections for leakage.

13. Check tire pressure and inspect tread.

14. Check front and rear fork bearing adjustment.

15. Check carburetor controls and adjustment.

16. Inspect brake pad linings and brake disc.

17. Check oil lines and fittings for leaks.

18. Inspect and clean spark plugs.

19. Check ignition timing and circuit breaker point condition and gap.

20. Check all nuts, bolts and screws, and tighten any found loose to specified torque.

21. Check and tighten wheel spokes.

22. Check clutch adjustment.

23. Change Model FX 1200 front fork with recommended oil.

24. Road test.

0 0

Post a comment