Note

Engine sprocket is aligned with clutch sprocket by a selection of spacers between sprocket and crankcase bearing. Reinstall same thickness of spacers as you removed, or determine correct spacer size as follows:

With clutch disassembled from clutch hub and compensating sprocket disassembled from sprocket shaft as shown, determine spacer (4, Figure 2-4) thickness as follows

Example (refer to Figure 2-4):

1. Measure from chain cover surface to alternator rotor recess 1.750

2. Measure from chain cover surface to clutch disc friction surface 1.437

3. Subtract measurement (Step 2) from measurement (Step 1) (5/16 in.) .313

4. Spacer thickness from table 120 in

Dimension Step 3

0 0

Post a comment