Function Of Regulator

Voltage Constant With Scr

While the engine r min is low and the generated voltage of the generator is lower than the adjusted voltage of regulator, the regulator does not function. However, the generated current charges the battery directly at this time. When the engine r min becomes higher, the generated voltage of the generator also becomes higher and the voltage between the battery terminals becomes high accordingly. When it reaches the adjusted voltage of the I.C., (Integrated Circuit) and it is turned ON, a signal...

Tester knob indication Diode test H

FUEL LEVEL INDICATOR LIGHT INSPECTION Lift the fuel tank and support it by prop. (dT' 4-4) Disconnect the oil pressure switch lead wire coupler. The fuel indicator light lights up for approx. 3 seconds after the ignition switch is turned on then the indicator light should go out. Disconnect the fuel level indicator switch lead wire coupler Connect a jumper wire between B W lead and R B lead coming from the main wiring harness and check whether fuel indicator light is flickering. Check if the...

Ignition Coil Primary Peak Voltage

Lift and support the fuel tank with its prop stay. C T 4-4 Remove all of the spark plug caps. CT 2-5 Connect two new spark plugs to each spark plug cap and ground them to the cylinder head. Make sure that all of the spark plug caps and spark plugs are connected properly and the battery is fully-charged. Measure ignition coil for 1 cylinder primary peak voltage in Connect the multi circuit tester with the peak voltage adaptor as follows. Ignition coil For 1 cylinder B Y terminal - Ground Do not...

Sidestandignition Interlock System Description

This side-stand ignition interlock system prevents the motorcycle from being started with the sidestand down. The system is operated by an electric circuit provided between the battery and ignition coil. G Green R Red Bl Blue O Orange O W To ignitor and ignition coil O Y Orange with Yellow tracer O B Orange with Black tracer O W Orange with White tracer Bl B Blue with Black tracer O W To ignitor and ignition coil The circuit consists of the turn signal side-stand relay, neutral indicator light...

Electrical System

7 9 STARTER SYSTEM AND SIDE-STAND IGNITION INTERLOCK STARTER SYSTEM SIDE-STAND IGNITION INTERLOCK SYSTEM STARTER MOTOR REMOVAL AND DISASSEMBLY 7-15 STARTER MOTOR STARTER MOTOR REASSEMBLY AND INSTALLATION 7-16 STARTER RELAY SIDE-STAND IGNITION INTERLOCK SYSTEM PART IGNITION SYSTEM DIGITAL TURN SIGNAL SIDE-STAND BRAKE TURN SIGNAL IGNITION SWITCH INITIAL RECHARGING

Turn Signal Sidestand Relay

The turn signal relay is corporated with the side-stand relay and diode to form the one component part which is called the turn signal side-stand relay. It is located under the seat. Remove the frame covers R , L and seat. Remove the turn signal relay D. Before removing the turn signal side-stand relay, check the operation of the turn signal light. If the turn signal light does not light, inspect the bulb, turn signal switch and circuit connection. If the bulb, turn signal switch and circuit...

Tester knob indication Diode test H4

B Black, B R Black with Red tracer, B W Black with White tracer NOTE If the tester read under 1.4V, replace the battery of multi circuit tester when do not connecting the tester probes. B Black, B R Black with Red tracer, B W Black with White tracer NOTE If the tester read under 1.4V, replace the battery of multi circuit tester when do not connecting the tester probes.