Figure 523D

6. Seal (11), if defective, can be pryed out from ignition side of gearcase. Use care not to damage camshaft end while prying.

7. Disconnect ignition module wires from coil.

8. To remove ignition module (13) from the frame, remove two mounting bolts, and the screw securing the ground wire to the frame.

CAUTION

This procedure will result in approximate timing and engine can be operated in an emergency for a short period of time. Advanced timing should be checked and set under running conditions as soon as possible using a strobe timing light as described in preceding section.

0 0

Post a comment