Inspection And Replacing Parts

Inspect lip of seal and replace if it worn or rough. Alsc replace the seal if there is any evidence of oil leakage intc the timer compartment.

Whenever ignition components have been disassembled, such as during engine disassembly and reassembly, or if a strobe timing light is not available, approximate timing can be obtained by using the following procedure:

1. Set sensor plate (8) so that sensor plate screws (6) are centered in the slots. Snug down the screws (6).

2. Engine can now be started.

3. Adjust the advanced timing following procedure in the preceding section.

0 0

Post a comment