Stoplight Switch

FRONT BRAKE SWITCH

To replace stoplight switch in right handlebar assembly (figure 5-5), remove cover (2) and rubber cap (9). Disconnect wires and unscrew switch (10) and washer (11) from housing. Switch must be replaced as a unit.

REAR BRAKE SWITCH

The rear stoplight switch is located in the rear brake hydraulic line. The stoplight switch is a normally open type switch which closes with hydraulic pressure. The switch parts are not serviceable and must be replaced as a unit.

Connect a test light of at least 21 CP (12v) between the orange wire at the terminal and ground. If the test bult lights up, power is reaching the switch. Next, depress the brake lever and hold it. Connect the test bulb between red wire at the terminal and ground. If the test bulb doesn't light, switch is faulty and must be replaced.

0 0

Post a comment