Awarning

Low pressure compressed air can blow debris into your face and eyes. Always wear eye protection or a face shield when using pressurized air. Failure to take adequate safety precautions could result in death or serious injury.

4. See Figure 2-56. Remove and discard both crossover o-

rings (1) from inside caliper housing.

5. See Figure 2-57. Remove pistons.

a. Place BRAKE CALIPER PISTON REMOVER (HD-43293) between caliper housings.

b. Insert three bridge bolts and tighten securely.

c. If the bleeder valve was removed, loosely reinstall or place a gloved finger over the bleeder valve hole on outside caliper housing.

d. Apply low pressure compressed air to banjo bolt hole to remove pistons from caliper bores.

e. Remove bridge bolts and remove tool.

6. If necessary, wiggle pistons from caliper bores to completely remove. Discard all removed parts.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment