Vrsca Throttle Cable Installstion

Do not apply excessive heat to idle air control. Apply only enough heat to break LOCTITE® patch on screws. Excessive heat will cause damage to idle air control.

6. See Figure 9-12. Using heat gun, apply heat to idle air control screws (2) to break LOCTITE® patch. Remove screws.

Iac Valve 883c Harley Davidson

1. IAC sensor connector [87B]

2. Idle air control (IAC)

3. Air intakes (covered)

1. IAC sensor connector [87B]

2. Idle air control (IAC)

3. Air intakes (covered)

Figure 9-11. IAC Sensor

1. Inspect IAC o-ring, replace if damaged.

2. Apply clean engine oil to IAC o-ring.

3. Place idle air control and o-ring into throttle body. Be sure o-ring is properly seated in throttle body groove.

4. See Figure 9-12. Apply LOCTITE® TREADLOCKER 243 (blue) to screws (2). Loosely install front and rear IAC screws (2).

5. Tighten front and rear IAC screws to 2-4 Nm (25-35 in-Ibs).

6. Connect throttle cables to throttle body.

7. Install throttle body. See 3.9 THROTTLE BODY.

8. Connect negative battery cable.

9. Install airbox and air filter. See 1.4 AIRBOX AND AIR FILTER.

Recondition Battery Guide

2. Screws

3. Throttle body

Figure 9-12. IAC Removal

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment