Headlamp Bulb

HEADLAMP LENS

Removal

NOTE

It Is not necessary to disassemble the headlamp assembly in order to replace headlamp bulbs.

1. See Figure 8-23. To replace the low beam (5) or high beam (7) headlamp bulb, reach behind the headlamp bucket (4) and grasp the appropriate headlamp bulb socket connector.

2. Squeeze the release latches on the connector and pull the connector away from the headlamp bulb.

3. While facing the headlamp from behind (looking toward the front of the motorcycle), twist the headlamp bulb approximately 45 degrees counterclockwise (ccw) and gently pull straight out of the headlamp.

Installation

NOTE

The low beam headlamp bulb (labeled H11) mounts in the top hole in the rear of the headlamp assembly. The high beam bulb (labeled H9) mounts in the bottom hole.

1. See Figure 8-23. To install a new headlamp bulb, insert it into the hole in the rear of the headlamp. Facing the headlamp assembly from the rear (looking toward the front of the motorcycle):

a. Position the low beam bulb (5) with its connector housing pointing to approximately 4 o'clock.

b. Position the high beam bulb (7) with it's connector housing pointing to approximately 5 o'clock.

2. Gently twist the bulb clockwise (CW) approximately 45 degrees, until it stops.

Removal

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment