Installation

1. See Figure 4-5. Push a new fuel pump (5) down into its bracket (3) against the screwed on bracket stop.

2. Route new crossover hose (6) on the side of the support rod (7) opposite the fuel level sender float.

3. Install new clamps over new crossover hose (6) and attach to the pressure side filter using side of HOSE CLAMP PLIERS (HD-41137).

4. If required, replace fuel pump wiring or fuel level sender wiring.

CAUTION

Do not replace the special teflon coated fuel pump wiring with ordinary bulk wire. Ordinary insulation materials may deteriorate when in contact with gasoline.

5. Press the black and red wire leads onto the clips.

6. Press a new suction side filter (4) onto the strainer inlet at the bottom of the fuel pump (5).

7. Install fuel pump/filters/fuel level sender assembly into gas tank. See 4.2 FUEL PUMP/FILTERS/FUEL LEVEL SENDER ASSEMBLY.

8. After installation of fuel pump/filters/fuel level sender assembly, verify fuel pump operation with a fuel system pressure test. See 9.10 FUEL PRESSURE TEST.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment