Installation

1. Lubricate the starter o-ring with Harley-Davidson Special Purpose Grease, Part No. 99857-97.

2. Install starter gear shaft into engine housing.

NOTE

Be sure starter gear shaft engages the teeth of the limiter assembly in the engine housing.

3. See Figure 5-6. Install the two starter mounting bolts and washers (1). Alternately tighten the bolts to 6-10 Nm (53-88 in-lbs).

4. Slide solenoid cable terminal ring (2) over starter post. Thread on and tighten hex-nut to 6-10 Nm (53-88 in-lbs).

5. Slide protective boot securely over terminal.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment