Removal

NOTE

If only replacing brake pads, see 1.10 BRAKE PADS AND DISCS.

CAUTION

Damaged banjo bolt surfaces will leak when reassembled.

Prevent damage to seating surfaces by carefully removing brake line components.

1. See Figure 2-42. Remove banjo bolt (1) and both steel/ rubber washers (2) to detach front brake line (3) from caliper. Discard washers.

2. Remove both upper (4) and lower (5) mounting bolts. Lift caliper upward to remove from brake disc.

3. Repeat for opposite side caliper.

Figure 2-42. Front Brake Caliper Mounting

1.

Banjo bolt

2.

Steel/rubber washer

3.

Front brake line

4.

Upper mounting bolt

5.

Lower mounting bolt

v0089x2x

Figure 2-43. Front Brake Caliper v0089x2x

Inside caliper housing

Square seal

Wiper

Piston

Crossover O-ring Anti-rattle spring Brake pads

Outside caliper housing

Decal

Pad pin

Bridge bolt

Bleeder valve

Figure 2-43. Front Brake Caliper

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment