Removal

^WARNING

To protect against shock and accidental start-up of vehicle, remove the maxi-fuse before proceeding. Inadequate safety precautions could result in death or serious injury.

1. Remove right side cover and remove maxi-fuse. See 8.5 MAXI-FUSE.

2. Remove airbox cover. See 1.4 AIRBOX AND AIR FILTER.

3. See Figure 9-6. Remove IAT sensor connector [89B].

a. See Figure 9-7. Depress wire form.

b. Use rocking motion to detach connector from IAT.

4. See Figure 9-8. Depress the retaining fingers (2) on the under side of IAT sensor and pull IAT sensor from upper airbox.

Note

A short length of tubing with an ID of 7.62 mm (.312 in) can be pushed over the retaining fingers to ease the sensor removal.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment