Removal

NOTE

Before removing the relay, perform diagnostics listed in the VRSCA Electrical Diagnostic Manual.

The starter relay Is located beneath the airbox cover In the fuse block.

1. Remove right side cover.

2. See Figure 5-4. Locate and remove maxi-fuse.

Figure 5-5. Starter Relay (fuse block cover removed)

Figure 5-4. Maxi-fuse

3. Unlatch and open seat.

4. Remove the airbox cover. See 1.4 AIRBOX AND AIR FILTER.

^warning

To protect against shock and accidental start-up of vehicle, disconnect the negative battery cable before proceeding. Inadequate safety precautions could result in death or serious injury.

5. Disconnect the negative battery cable.

6. See Figure 5-5. Locate fuse block behind air cleaner. Pull fuse blocks from tabs on mounting bracket. Tabs on bracket fit into slots on each side of fuse block cover. To remove cover, raise latches slightly to disengage tabs on fuse blocks.

7. Remove gray starter relay from fuse block with single relay.

Figure 5-5. Starter Relay (fuse block cover removed)

1. Install relay in fuse block.

2. Slide cover over fuse blocks until latches fully engage tabs on blocks.

3. Slide fuse blocks onto frame mounting bracket. Tabs on bracket fit into slots on each side of fuse block cover.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment