Float

FLOS* r

TOP view or CA HBUHCTOA BOWL v5*/0*V/A/a ft- OA T CHAMtSM

TOP view or CA HBUHCTOA BOWL v5*/0*V/A/a ft- OA T CHAMtSM

V/£h/ OF CARBURETOR

AMD +SL o J SO & y U<S^,AA/D /DL£ CHAM A/ELS

ILLUS. Ill

Assembling Carburetor

13. Install all channel opening plug screws.

Install venturi with choke end (small end) facing air intake opening, and insert spray nozzle through body channel and venturi, as shown in Illus. 109. Spray nozzle is retained by spring and bowl nut.

14. Install spray nozzle retaining spring in body hole, locate bowl assembly on body, (O.H.V. Model carburetor only—install bowl gasket between bowl and body) install copper washer, and turn on bowl retaining nut. See that bowl fuel line nipple is in correct position and tighten bowl nut.

15. Install throttle shaft and pass throttle disc through shaft slot so that counterbored screw holes in shaft and the scribed mark on disc face the manifold end of carburetor body. Install throttle disc re taining screws but don't tighten them as yet. Close the throttle disc making sure scribed mark on disc lines up with scribed mark in barrel (if new disc is installed disregard this), and collar on lower end of throttle shaft is tight against carburetor body. Hold throttle shaft and disc snugly in this position and tighten disc retaining screws. Try opening and closing throttle disc to see that it does not bind, and also closes off the barrel hole completely. Install throttle shaft wear take-up spring on shaft and install throttle lever. Open throttle disc wide open in the barrel and clamp throttle lever on the shaft with wide open stop against body stop. Throttle lever and shaft should open and close with just slight drag.

Occasionally throttle shaft and throttle shaft bushings may need renewing. When renewing bush-

L&L MANUFACTURING C6 MAOC IN

V/EW OF CARBURETOR SHOWING HiGH SPEED NEEDLE VALVE AND ONE BODY fiLUG.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment