Self Diagnostic Procedures

Place the motorcycle on its side stand. Start the engine and let it idle.

If the malfunction indicator does not light or blink, the system has no memory of problem data. If the malfunction indicator blinks, note how many times the malfunction indicator blinks, and determine the cause of the problem (page 5-12 through 5-54).

MALFUNCTION INDICATOR

MALFUNCTION INDICATOR

The malfunction indicator will start blinking only with the side stand down and with the engine off (engine stop switch on) or engine revs are below 5,000 rpm. In any other conditions, the malfunction indicator will illuminate and stay on.

AFTER '99 MALFUNCTION INDICATOR

If you wish to read the PGM Fl memory for trouble data, perform the following:

Turn the ignition switch to "Of-F".

IGNITION SWITCH

IGNITION SWITCH

Remove the seat (page 2-2).

Short the PGM-FI system service check connector terminals using a jumper wire.

Be sure the engine Turn the iynition switch to "ON". stop switch is in the on position. If the ECM has no self diagnosis memory data, the malfunction indicator will illuminate and stay lit, when you turn the ignition switch to "ON".

If the ECM has self diagnosis memory data, the malfunction indicator will start blinking when you turn the ignition switch to "ON".

NOTE:

Even if the PGM-FI has memory data, the malfunction indicator only illuminates (does not blink) under engine running conditions (side stand up and revs above 5,000 rpm).

Note how many times the malfunction indicator blinks, and determine the cause of the problem (page 5-12 through 5-54).

+1 0

Post a comment