Ignition Timing

Warm up the engine

Stop the engine and connect a timing light to the spark plug wire.

NOTE_

■ Read the manufacturer's instructions for the timing ' light before operating^_____|

Remove the following :

-Right side fairing (page 2-3)

-Ignition pulse generator rotor cover cap.

Start the engine and let it idle.

49-State and Canada type:

The timing is correct if the F mark (notch mark) aligns with the index mark on the ignition pulse generator rotor cover.

Increase the engine speed by rotating the throttle stop screw and make sure the F mark begins to move counter clockwise at approximately 1.600 rpm.

California type:

The timing is correct if the F marklpunch marks) aligns with the index mark on the ignition pulse generator rotor cover.

Increase the engine speed by rotating the throttle stop screw and make sure the F mark begins to move counterclockwise at approximately 1,900 rpm

Timing Marks Cbr600Motorcycle Timing Marks

IGNITION PULSE GENERATOR CONNECTOR

IGNITION PULSE GENERATOR CONNECTOR

Ignition Pulse Generator Rotor Cover Removal/Installation

Requisite Service

■ Fuel tank removal/installation(page 2-11) • Left crankcase cover removal/installationipage 15-7)

(This is necessary if yotr plan to remove the pulse generator rotor.)

Procedure

Q'ty

Remarks

Removal Order

Installation is in the reverse order of removal

(1)

Ignition pulse generator connector

1

(2)

Ignition pulse generator rotor cover bolt

• Apply sealant to the threads of the bolts iadicated by "A" marks.

(3)

Ignition pulse generator rotor cover

1

(4)

Dowel pin

2

(5)

Gasket

1

(6)

Bolt

2

(7)

Ignition pulse generator

1

When installing, apply sealant to the grommet and intall the yrommet securely into the groove in the ignition pulse generator rotor cover.

(8)

Ignition pulse generator rotor bolt

* Remove the left crankcase coverlpage 1 5 -7] and loosen the bolt while hold ing the flywheel with a flywheel wrench (No.07925-M£90000).

• Be careful not to damage the rotor teeth during removal and installation.

(9)

Washer

1

(10!

Ignition pulse generator rotor

1

+1 0

Responses

  • ren
    How to set honda cbr 600 timing?
    2 years ago
  • Robyn
    How 2 set timing for honda cbr1000rr 2016 engine timing?
    1 year ago

Post a comment