Coolant Temperature Gauge

Remove the middle fairing (page 2-4).

Disconnect the connector from thermosensor and short it.

Turn the ignition switch ON.

(1) JUMPER WIRE

The temperature gauge needle should move all the way to H and battery voltage should register.

CAUTION

* Do not leave the thermosensor wire shorted for longer than a few seconds or the temperature gauge will be damaged._

If battery voltage registers, but the temperature gauge does not move, replace the thermosensor.

If the battery voltage does not register, check the connectors for a loose or blown fuse.

Short the thermosensor connectors again.

If battery voltage does not register, there is an open circuit in the wire.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment