Oil Pressure Switch

NOTE

To check the oil pressure, refer to Section 4 of the Common Service Manual.

Remove the middle fairing (page 2-4).

Disconnect the oil pressure switch wire from the switch by removing the terminal screw and short it.

Turn the ignition switch ON.

The oil pressure warning light should come on and battery voltage should be measured.

If the battery voltage is present, but oil pressure warning light does not come on, replace the oil pressure switch. If the battery voltage is not measured and the oil pressure warning light does not come on, check the connectors for loose connection and check for a blown fuse or burnt out bulb.

Short the oil pressure switch wire again.

If the battery voltage is not measured, there is an open circuit in the wire.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment