Assemblyinstallation

(1) CASE AND FIELD COIL

(2) ARMATURE

(4) BRUSH HOLDER

(5) BRUSH SPRING

O-RING

(1) CASE AND FIELD COIL

(2) ARMATURE

(4) BRUSH HOLDER

(5) BRUSH SPRING

O-RING

<10} FRONT COVER

(8) CABLE: TERMINAL AND BRUSHES

(7) REAR COVER

<10} FRONT COVER

(8) CABLE: TERMINAL AND BRUSHES

(7) REAR COVER

1} COMMUTATOR BAR

(1) COMMUTATOR BAR

Assemble the starter motor.

Align the starter motor ease notch with the brush holder tab.

NOTE

- Do not forget to install the thrust washers.

ยก1) THRUST WASHERS

Install the rear cover, aligning its slot with the brush holder tab.

(2) INDEX-MARKS

Shift the transmission into the neutral.

Disconnect the connector from the starter relay.

Measure the voltage between the yellow/red and green/red wire terminals of the connector at the harness side.

Turn the ignition switch "ON".

There should be battery voltage while the starter switch is depressed.

If the there is no voltage, check for loose contact of the neutral switch, sub fuse and connector, or an open circuit in the wire harness.

Install the starter motor in the reverse order of removal.

(2) INDEX-MARKS

STARTER RELAY SWITCH

0 0

Post a comment