Service Rules

1. Use genuine HONDA o? HONDA-recommended parts and lubricants or their equivalents. Parts that do not meet HONDA'S design specifications may damage the motorcycle.

2. Use the special tools designed for this product.

3. Use only metric tools when servicing this motorcycle. Metric bolts, nuts, and screws are not interchangeable with English fasteners. The use of incorrect tools and fasteners may damage the motorcycle.

4. install new gaskets, ("ยก--rings, cotter pins, lock plates, etc. when reassembling.

5. When tightening a series of bolts or nuts., begin with the larger-diameter of inner bolts first, and tighten to the specified to-que diagonally, in incremental stops unfoss a ptsronuiyr sociuonoo is spocifiod.

6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.

7. After reassembly, check all parts for proper installation and operation.

8 Route all electrical wires as shown on pages 1-11 through 1-19, Cable and Harness Routing.

'87 shown

The frame serial number is stamped on the right side of the steering head.

0 0

Post a comment