Wire Harness Inspection

With the ignition switch turned to OFF, disconnect the regulator rectifier 4P connector. Measure the voltage between the Red white wire terminal (+) of the wire harness side connector and ground (-). There should be battery voltage at all times. Check for continuity between the Green wire terminal of the wire harness side connector and ground (-). There should be continuity at all times. Remove the left side cover (page 2-2). With the ignition switch turned to OFF, disconnect the alternator 3P...

Service Rules

Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that don't meet Honda's design specifications may cause damage to the motorcycle. 2. Use the special tools designed for this product to avoid damage and incorrect assembly. 3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with English fasteners. 4. Install new gaskets, O-rings, cotter pins, and lock plates when reassembling. 5. When tightening...

High Altitude Adjustment

This ad ustment When the vehicle is to be operated continuously above 2,000 m 6,500 feet , the carburetor must be readjusted as described below to improve driveability and decrease exhaust emissions. Warm up the engine to operating temperature. Ride the motorcycle for approximately 10 minutes. Turn the pilot screw in to the specification given. mut be made at high altitude to ensure proper high altitude operation Adjust the idle speed with the throttle stop screw knob. Attach the Vehicle...