Hub Bearing Installation

• Before installing the wheel bearings, blow any dirt or foreign particles out of the hub with compressed air to prevent contamination of the bearings.

• Replace the bearings with new ones.

• Press in the bearings until they are bottomed.

Special Tool - Bearing Driver Set: 57001-1129 [A]

NOTE

O Install the bearings so that the marked side faces out.

• Replace the circlips with new ones.

Special Tool - Inside Clrcllp Pliers: 57001-143

• Replace the grease seals with new ones.

• Press in the grease seals so that seal surface is flush with the end of the hole.

O Apply high temperature grease to the grease seal lips. Special Tool - Bearing Driver Set: 57001-1129 [A]

0 0

Post a comment