Brake pipes and fittings

All the brake pipes used on the disc brake Laverdas are of high quality and easily removed and fitted.

Check the fittings for weeping, perishing. corrosion and abrasion. Any suspicious components should be investigated immediately and retraced if damage is confirmed. Check all the fittings are clean and properly installed. It is obvioas where copper washers should be installed and how the pipes should ran. Flexible pipes shou_e re regularly replaced every four years at a minimum. For front disc brakes, the brake light switch is pressure operated and fitted into the system's distributor block under the lower fork yoke On rear disc systems, the brake light switch is in the rear master cylinder body or caliper , acting as a banjo bolt.

0 0

Post a comment