Assembling Front Wheel

1963 and Earlier (Fig. 2C-11)

Assemble washer (3) open end ball bearing (2) bearing lock nut (1). Peen lock nut to hub in two places. Insert front wheel bearing spacer (4) and press closed end ball bearing (5) into hub against bearing spacer (4), closed end facing out. Insert retainer (6). Install front wheel in motorcycle as described in "Removing and Installing Front Wheel."

1964 and Later (Fig. 2C-11A)

Clean and pack both ball bearings with fresh Grease-All grease. Press brake side ball bearing (4) against shoulder in hub, shielded side out. Install retaining ring (2) using Tru-arc lock ring pliers. Install bearing spacer (5). Press ball bearing (3) against shoulder in hub and 'tap grease retainer (1) in place.

ASSEMBLING REAR WHEEL HUB (Fig. 2C-12)

Press oil seal (2) into lock nut (1) and insert outer spacer (3) in oil seal (2) and lock nut (1). Install washer (5) and ball bearing (4). Assemble lock nut (1), oil seal (2), and outer spacer (3) into hub as one unit. Peen lock nut to hub in two places and insert bearing spacer (6).

1962 and Earlier

Press ball bearing (7) into hub against bearing spacer (6). Insert bearing spacer (8) and grease retainer (9). Install rear wheel in motorcycle as described in "Removing and Installing Rear Wheel."

1963 and Later

Press unshielded bearing (7A) against bearing spacer (6). Install bearing spacer (8A), and shielded bearing (9A) with oil seal (9) on outside.

0 0

Post a comment