Ft I

JrJ 1


Figure 3D-17. Installing Pinion Gear

Install pinion gear using Gear Puller and Installer Tool as shown in Fig. 3D-17.

Turn screw (1) on end of pinion shaft and tighten securely. Position gear locating collar (2) and body (3) on screw (1). Turn tool body to press gear into position until locating collar firmly contacts joint face of crankcase. This positions pinion gear outer face exactly 5 16 in. from gearcase joint face, the running position for the gear when case cover is in place.

0 0

Post a comment