Info

Shock absorber unit

Figure following name of part indicates quantity necessary for one complete assembly.

Figure 2F-37A. 1967 and Later Rear Shock Absorber - Exploded View Revised: 9-66 2F-25

(7) from retaining flange inside absorber cover (8). Remove shock absorber and spring (9) from cover and slip lower cam (10), spring rotating cam (11 or 11 A), cam sleeve (12), dirt seal (13) and washers (14) off shock absorber (15). Shock absorber bumper (7) is split and may be sprung and slipped off absorber piston shaft after it has been extended.

Remove top and bottom mounting stud nut (1), upper stud cover (2) if used, and cup washer (3). Slip shock absorber assembly off upper and lower studs. Push rubber bushings (4) from shock absorber mounting eyes. Remove retaining ring (5) from assembly. Place shock absorber in Rear Shock Absorber Tool, 97010-52A with split key (6) up. Compress absorber spring enough to remove each half of split key (6) from flange on shock eye. Release spring compression and remove absorber assembly from tool. Remaining items can be removed in order shown in Fig. 2F-37A.

0 0

Post a comment