Info

(counterclockwise)

(counterclockwise)

Figure 2C-15. Inserting Spokes in Rear Wheel Hub

7. Insert spokes (5, Fig. 2C-15) in ten inner spoke holes of opposite flange, (upper flange as positioned on workbench), and swing loose end of spokes clockwise as far as hub will allow. Then, insert inner spokes in nearest upper rim holes that angle in same direction as spokes and start nipples.

8. Insert spokes (6, Fig. 2C-15) in remaining ten outer spoke holes of upper flange and swing end of spokes counterclockwise as far as hub will allow.

9. See Fig. 2C-16. Select any outer spoke (3), cross it over four inner spokes (4), and insert spokes in nearest upper rim holes. Start nipples.

1. Brake side flange inner spoke

2. Brake side flange outer spokes 3 Upper flange outer spoke

4. Upper flange inner spokes

Figure 2C-16. Lacing Rear Wheel

Figure 2C-18. Truing Rim Concentric with Hub

Figure 2C-17. Truing Rim Sideways NOTE

Outer spokes on both sides should point in same direction.

0 0

Post a comment