Note

If blocking is not available work on only one shock absorber at a time, the other shock absorber will hold the rear fork and frame in place.

1966 and Earlier (Fig. 2F-37):

Loosen shock absorber cover clamp (1) and slip off shock absorber top cover (2) exposing shock absorber top stud. Remove top and bottom mounting stud nut (3), stud cover (2A), washer (4 or 4A), stud rubber bushing (5), and slip shock absorber assembly off upper and lower studs.

Position shock absorber upside down in rear fork shock absorber tool, Part No. 97010-52A as shown in Fig. 2F-38. Compress absorber spring enough to turn lower stud eye 90° into the cam support slot.

Release spring compression and remove absorber assembly from tool.

Slip off cam support (6), turn absorber end for end and rap lower end sharply on surface to free bumper

ASSEMBLE CAMS (ITEM NO. 12) SO THAT THE HIGH LOBES (WITH NOTCHES IN THE TIPS)ARE NEXT TO EACH OTHER AS SHOWN.

0 0

Post a comment