Note

If Timken bearing left half (11, Fig. 3E-20) and outer spacer are already installed in case, simply position case over top of screw (1, Fig. 3E-30) until bearing is snug on sprocket shaft and proceed as follows.

Install bearing sleeve (3) over end of screw (1, Fig. 3E-30) with step-cut end of sleeve facing down as positioned on tool.

Start driver (2, Fig. 3E-30) on screw and turn driver down against bearing sleeve. Continue turning the driver clockwise until the two bearing halves are brought tight against spacer. Remove tools.

0 0

Post a comment