Note

The following stripping procedure applies to the standard XL and XLH Models. The same procedure may be used for the XLCH Model except for some changes in procedure due to differences in equipment.

STRIPPING MOTORCYCLE FOR ENGINE REPAIR (See Fig. 3A-7 or 3A-8)

1. Clean engine thoroughly with "Gunk" to remove all road dirt. Remove "Gunk" and dirt with water spray and blow engine dry with compressed air. Drain gasoline and oil. Remove seat. Disconnect

1. Gasoline line

2. Gasoline tank interconnecting line 2A. Vent line (1966 & later)

3. Cleaner assembly

4. Throttle cable connection

5. Engine support bolt location

6. Exhaust pipe port clamp (2)

0 0

Post a comment