Figure 3E-27. Checking Connecting Rod Sideplay

1. Guide sleeve

2. Crankcase main bearing lap

Figure 3E-28. Main Bearing Lapping Tools

4. Cracked flywheel at tapered hole. Replace flywheel.

If sides of forked rod are ground to get desired clearance, backs of bearing retainers must be ground down to remain narrower than width of female rod.

After rod sideplay is checked and adjusted, crank pin nut pulled very tight and lock plate and screw installed, check wheel trueness on truing device. Correct any run-out as above.

0 0

Post a comment