Starting Circuit Cutoff Relay

Inspection

1. Remove the left side cover.

2. Remove the starting circuit cut-off relay from the rubber clamp, and disconnect the connector.

STARTING CIRCUIT

STARTING CIRCUIT

Cut Off Relay

1. When the battery is connected

2. When the battery is disconnected

3. 12 volt battery

1. When the battery is connected

2. When the battery is disconnected

3. 12 volt battery

Yamaha Warrior Cut Off Relays

1. Starting circuit cut-off relay

2. Sidestand relay

1. Starting circuit cut-off relay

2. Sidestand relay

3. Check the resistance of the relay coil windings with the pocket tester. If the resistance is not within specification, replace the relay.

5. Check the diode in the starting circuit cutoff relay with the pocket tester as shown in the illustration. Replace the relay if the diode is damaged.

Diode Motorcycle

Only the Yamaha Pocket Tester will give a 9.517 reading when testing continuity. The particular characteristics of other testers will vary the continuity test readings.

+1 0

Post a comment