Note

► Install the pull rod so that the teeth a face towards the rear of the motorcycle. Then, install the clutch cover. ►Apply oil onto the bearing. ►Apply molybdenum disulfide grease onto the pull rod.

►When installing the clutch cover, push the pull lever and check that the punch mark @ on the pull lever aligns with the mark ® on the clutch cover. Make sure that the pull rod teeth and pull lever shaft pinion gear are engaged. Tighten the clutch cover bolts in stages and in a crisscross pattern.

10. Adjust: • clutch cable free play Refer to "ADJUSTING THE CLUTCH CABLE FREE PLAY" in chapter 3.

EAS00356

0 0

Post a comment