Removal and installationsk

A Warning If the engine has been running the exhaust system will be very hot. Allow the system to cool before carrying out any work. 1 On YZF750R and SP models, for improved clearance and to avoid the possibility of damage, remove the lower fairing (see Chapter 8). Slacken the clamp bolt securing the silencer pipe to the downpipe assembly. Unscrew and remove the silencer mounting bolt, then release the silencer pipe from the downpipe assembly. Remove the sealing ring from the end of the...

Info

4.1 Measure the voltage to determine the charging time required 5.1a Fusebox- 5.1b Fusebox- 5.1c Main fuse (arrowed)- YZF750R and SP models YZF1000R models YZF750R and SP models 3.10 Measure the voltage to assess the condition of the battery from the chart 4.1 Measure the voltage to determine the charging time required Refer to Section 4 and charge the battery once every month to six weeks. 10 The condition of the battery can be assessed by measuring the voltage present at the battery...

Motorcycle Axial Runout

1 In order to carry out a proper inspection of the wheels, it is necessary to support the bike upright so that the wheel being inspected is raised off the ground. Position the motorcycle on an auxiliary stand. Clean the wheels thoroughly to remove mud and dirt that may interfere with the inspection procedure or mask defects. Make a general check of the wheels (see Chapter 1) and tyres (see Daily (pre-ride) checks). 2 Attach a dial gauge to the fork or the swingarm and position its tip against...

H28946

5.2 Unclip the lid to access the fusebox fuses 5.3 A blown fuse can be identified by a break in its element 2 To access the fusebox fuses, remove the rider's seat (see Chapter 8) and unclip the fusebox lid (see illustration). To access the main fuse on YZF750R and SP models remove the fuel tank (see Chapter 4) (see illustration 5.1c). On YZF1000R models remove the left-hand side cover (see Chapter 8), then remove the fuse cover from the relay (see illustration 5.1 d). 3 The fuses can be removed...

Getting back on the road

Exhausts can be sealed off with a plastic bag Disconnect the negative lead (A) first, followed by the positive Use a suitable battery charger - this kit also assess battery condition then switch off and allow to cool. Tape a piece of thick plastic over the silencer end(s) (see illustration 5). Note that some advocate pouring a tablespoon of motor oil into the silencer(s) before sealing them off. Remove it from the bike - in extreme cases of cold the battery may freeze and crack its case (see...

Yamaha Yzf750r Fuel Pump Torque Settings

22.7 The sidestand switch is secured by two screws (arrowed) good, check the wiring between the various components (see the Wiring Diagrams at the end of this Chapter). 4 The clutch switch is mounted on the underside of the clutch lever bracket. 5 Disconnect the wiring connector (see illustration 23.2), then remove the screw and detach the switch. 6 Installation is the reverse of removal. 1 The starter circuit cut-off relay is part of the safety circuit which prevents or stops the engine...